Chapter 12 Description of Parameter SettingsME300
12.1-01-1
01 Basic Parameters You can set this parameter during operation.
Maximum Operation Frequency of Motor 1
Maximum Operation Frequency of Motor 2
Default: 60.00 / 50.00
Settings 00.00–599.00 Hz
Determines the drive’s maximum operation frequency range.
This setting corresponds to the maximum value for the analog input frequency setting signal
(0–10 V, 4–20 mA, 0–20 mA, ±10 V).
Output Frequency of Motor 1
Output Frequency of Motor 2
Default: 60.00 / 50.00
Settings 00.00–599.00 Hz
Set this value according to the motor’s rated frequency from the motor’s nameplate.
If the motor’s rated frequency is 60 Hz, set the value to 60 Hz. If the motor’s rated frequency is 50
Hz, set the value to 50 Hz.
Output Voltage of Motor 1
Output Voltage of Motor 2
Default: 220.0 / 440.0
Settings 115V/230V series: 0.0–255.0 V
460V series: 0.0–510.0 V
Set this value according to the rated voltage of the motor from the motor’s nameplate. If the
motor’s rated voltage is 220 V, set the value to 220.0 V. If the motor’s rated voltage is 200 V, set
the value to 200.0 V.
There are a wide variety of motors, but the power system for each country is different. The
convenient and economical way to solve this problem is to use an AC motor drive, which can
deal with different voltages and frequencies, while supporting the original characteristics and life
of the motor.
Mid-point Frequency 1 of Motor 1
Default: 3.00
Settings 0.00–599.00 Hz
Mid-point Voltage 1 of Motor 1
Default: 11.0 / 22.0
Settings
15V/230V series: 0.0–240.0 V
460V series: 0.0–480.0 V
Mid-point Frequency 1 of Motor 2
Default: 3.00
Settings 0.00–599.00 Hz
To Next Page
Loading...
Need help?
General