22
ENGLISH
Getting Started Connections Playback Remote Control Information Troubleshooting Specifi cationsMulti-Zone
The acoustic characteristics of the connected speakers and
listening room are measured and the optimum settings are made
automatically.
NOTE
• Loud test sounds may be played during “Audyssey Auto Setup”. This
is part of normal operation. If there is background noise in room,
these test signals will increase in volume.
• Do not stand between the speakers and setup microphone or allow
obstacles in the path while the measurements are being made. This
will cause inaccurate readings.
• Make the room as quiet as possible. Background noise can disrupt
the room measurements. Close windows, silence cell phones,
televisions, radios, air conditioners, fl uorescent lights, home
appliances, light dimmers, or other devices as measurements may
be affected by these sounds.
Cell phones should be placed away from all audio electronics during
the measurement process as Radio Frequency Interference (RFI)
may cause measurement disruptions (even if the cell phone is not in
use).
Audyssey MultEQ
®
automatically measures the acoustical
problems in the listening environment to create the best audio
experience for your home theater.
• When “Audyssey™ Auto Setup” is performed, MultEQ
®
, Dynamic
EQ™ and Dynamic Volume™ functions (vpage 48) are enabled.
• Use the included setup microphone (DM-A409) to perform “Audyssey
Auto Setup”.
• Measurements are performed by placing the calibrated microphone
successively at multiple positions throughout the listening area as
shown in GExample qH. For best results, it is strongly recommended
to measure 6 positions so that the measurements have the proper
spatial weighting.
Even if the listening environment is small as shown in GExample wH,
measuring at multiple points throughout the listening environment
results in more effective correction.
n When using Front Height Speakers
GExample qH GExample wH
( : Measuring positions)
Important Information
About the main listening position (*M)
The main listening position refers to the most central position where
one would normally sit within the listening environment.
MultEQ uses the measurements from this position to calculate
speaker distance, level, polarity, and the optimum crossover value
for the subwoofer.
FHL : Front height speaker (L)
FL : Front speaker (L)
SW : Subwoofer
C : Center speaker
FR : Front speaker (R)
FHR : Front height speaker (R)
SR : Surround speaker (R)
SBR : Surround back speaker (R)
SBL : Surround back speaker (L)
SL : Surround speaker (L)
( : Measuring positions)
n Check Audyssey Auto Setup Measurement
Results (Parameter Check) (vpage 26)
Audyssey Auto Setup Flown
a Connect the included Setup Microphone
(vpage 23)
d Performing “Audyssey Auto Setup”
Procedure (vpage 24)
s Audyssey Auto Setup Preparations
(vpage 23)
n Changing the amplifi er assignment (Amp Assign)
(vpage 23)
n Set the channel to be measured (Channel Select)
(vpage 24)
Settings
Making the Optimum Settings for the Connected Speakers Automatically
(Audyssey™ Auto Setup)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
