Denon DHT-FS3 User Manual

ENGLISH
Optimum installation layout
The DHT-FS3 can reproduce a realistic 5.1-channel surround sound for enhanced sense of presence using
just the front speaker unit and the subwoofer.
Ideal layout examples
<Installed flat against a wall> <Installed in a corner>
Installation tips
Installing as shown below provides a better surround effect.
• Listen from a distance of at least 1 meter from the front speaker unit.
• Keep the front speaker unit away from the left and right walls.
• When mounting in a TV rack, use with the door opens.
Connecting the front speaker unit and subwoofer
Use the exclusive connection cable to connect.
b To disconnect the
plug, press down on
the lock lever and
pull.
Lock lever
<View from the bottom>
E
<Close-up>
Changing the speaker connection cable
The included connection cable can be replaced, for example if you want a longer cable.
q Pressing the release button on the opposite side
from lock lever, pull the cable out of the plug.
w Peel off the sheathing from the tip of the new
cable and twist tightly so that the tip is not
frayed.
e Pressing the release button, insert the cores into
the plug, matching the cable’s + and – polarities
with the + and – sides on the plug.
r Release the release button and gently pull on
the cable to check that it is secure.
Release button
Release button
Lock lever
0.03 ft /
10 mm
NOTE:
• Do not place any heavy objects (TV, etc.) on top of the DHT-FS3.
• The size of the room, the distance between the DHT-FS3 and the listening position, etc., can be set using
the “ROOM” option in the “Detailed settings” (vpage 11).
NOTE:
• Be sure to insert the connection cable’s plug
fully to the hilt. Incomplete connections will
cause noise or operating problems.
InstallationGetting Started Connections Settings Operation Other functions
Operating the
remote control unit
Troubleshooting Specifications

ENGLISH
NOTE:
• Speaker connection cables of up to 1.2 mm in thickness can be connected to the DHT-FS3’s speaker
terminal.

Denon DHT-FS3 Specifications

General

Audio decoders	Dolby Digital, Dolby Pro Logic II, DTS
RMS rated power	110 W
Audio output channels	5.1 channels
Signal-to-Noise Ratio (SNR)	100 dB
Satellite speaker frequency range	150 - 20000 Hz
Subwoofer frequency range	45 - 150 Hz
Subwoofer driver diameter (imperial)	6.23 \
Power consumption (standby)	1 W
Power consumption (typical)	32 W

Weight and Dimensions

Subwoofer weight	5600 g
Center speaker weight	4600 g
Subwoofer dimensions (WxDxH)	380 x 360 x 106 mm
Center speaker dimensions (WxDxH)	96 x 125 x 850 mm