ENGLISH
Getting Started Installation Connections Settings Operation Other functions Troubleshooting Specifications
Operating a component stored in the preset
memory
1
Set [MODE SELECTOR] to the component you want to
operate.
2
Operate the component.
b For details, refer to the component’s operating instructions.
b Some models cannot be operated with this remote control unit.
Operating the remote control unit
Setting the preset memory function
About the button names in these explanations
< > : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
1
Set [MODE SELECTOR] to the component to be
registered.
2
Press [TV VOL –] and [p] at the same time.
• The indicator starts flashing.
3
Referring to the included list of preset codes, press
[NUMBER] to input the preset code (a 3-digit number)
for the manufacturer of the component whose signals
you want to store in the memory.
4
To store the codes of another component in the
memory, repeat steps 1 to 3.
Operating DENON audio components
1
Set [MODE SELECTOR] to the position for the
component to be operated (TV, SAT/CABLE or
DVD).
2
Operate the audio component.
b For details, refer to the component’s operating instructions.
b While this remote control is compatible with a wide range of
infrared controlled components, it may be the case that some
component models cannot be operated with this remote control.
•
DENON and other makes of components can be operated by setting
the preset memory.
• This remote control unit can be used to operate components of other
manufacturers without using the learning function by registering the
manufacturer of the component as shown in the list of preset codes
(vEnd of this manual).
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit’s transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• When using a TV, SAT/CABLE and/or DVD, it is only possible to store
the signals for one of these units in the preset memory.
ENGLISH
Operating the
remote control unit
To Next Page
Need help?
General
Weight and Dimensions
