ENGLISH
ENGLISH
Detailed Settings
1
At [SETUP], select the rst menu.
2
Press [ENTER].
• The second menu is displayed.
3
Use [ui] to select, then press
[ENTER].
b Set the third menu in the same way.
• Select the different items on the menus while
they are displayed (within 5 seconds).
• The settings remain in effect even after the power
has been turned off.
• Settings indicated by are the factory
defaults.
SettingsGetting Started Installation Connections Operation Other functions
Operating the
remote control unit
Troubleshooting Specifications
• Set this to “ON” when listening with the volume
low (for example at night) to make the dialogs
more distinct.
• Valid for “DOLBY” and “DTS” digital audio input
sources.
• Turns on when an audio input is detected.
Turns off if no signal is input for over 10 minutes.
• Turn this on when connecting an AV amplifier and
using for the center speaker and subwoofer. The
DHT-FS3’s surround-related functions are turned off.
• The surround level is higher for the MOVIE mode
than for the MUSIC mode.
Use to select,
to set.
Adjustment range:
0 dB
or
+6 dB
TONE
Tone adjustment (bass/treble)
FADER
Front/rear volume balance adjustment
NIGHT
Night mode setting
ROOM
Settings for the installation position and
wall hardness
(how the sound reflects)
GAIN
Adjustment of the input level for the
different analog input functions
DELAY
Adjustment of the audio delay time
PWR ON
Auto power mode setting
CENTER
Speaker mode setting
DUAL
Bilingual audio setting
Set
Set
BASS
Bass level
TREBLE
Treble level
OFF
Normal balance
MOVIE
For movie sources
MUSIC
For music sources
OFF
Normal playback
ON
Night mode on
DIST
Distance to listening position
OFFSET
Offset from center
REFL
How sound reflects off walls
TV
b
Sound connected to TV input
terminals
AUX
b
Sound connected to AUX
input terminals
Adjustment range:
0 ms
~
170 ms
ON
Auto power on
OFF
Low standby power mode
MAIN
Main audio played
SUB
Sub audio played
M/S
Both main and sub audio played
OFF
Normal playback
ON
DHT-FS3’s surround function off
Set
Set
Set
Set
Set
Set
Distance adjustment range:
3.9 ft / 1.2 m
~
8.9 ft / 2.7 m
~
17.7 ft / 5.4 m
Offset distance adjustment range:
2.9 ft / 0.9 m to 9.8 ft / 3.0 m for both L and R. This
depends on the setting of the distance to the listening
position (“DIST”).
Reflection setting items:
SOFT
…When there are curtains, etc.
MEDIUM
…For wood or other soft walls
HARD
…For glass or hard walls, etc.
Adjustment range:
–12 dB
~
0 dB
~
+12 dB
Set
Set
Set
Set
Use to select,
to set.
Use to select,
to set.
1st menu
2nd menu
3rd menu
To Next Page
Loading...
Need help?
General
Weight and Dimensions
