19
8514-300-001 REV PR
7 Instrucons
INFORMATION
This washer may have been purchased as
part of a stacked washer/dryer. In
addition to these instructions, please also
refer to the installation instructions that
accompany the dryer when installing this
product.
7.1 Installaon
INFORMATION
All washers must be installed in
accordance with all local, state and
national building, electrical, plumbing and
other codes in effect in the area.
Electrical safety of these washers has
been evaluated to the requirements of
European standard EN 60204-1.
7.1.1 Foundaon Requirements
T-300 and 400:
This machine is designed for use on or over bare concrete floor - not to be used above
combustible flooring, such as carpet or wood. The washer must be securely bolted to a
substantial concrete floor or mounted upon a suitable base that is securely bolted to a
substantial concrete floor. Grouting is highly recommended, especially to the concrete surface.
See Machine Grouting section for details.
T-350, 450, 600, 650, 750, 900, 350 SWD and 450 SWD:
This machine is designed for use on or over bare concrete floor - not to be used above
combustible flooring, such as carpet or wood. The washer must be securely bolted and
grouted to a substantial concrete floor or mounted and grouted upon a suitable base that is
securely bolted and grouted to a substantial concrete floor. See Machine Grouting section for
details.
WARNING
INSTALLATION AND SERVICING
INSTRUCTIONS ARE FOR USE BY
QUALIFIED PERSONNEL ONLY. TO
AVOID INJURY AND ELECTRICAL SHOCK
DO NOT PERFORM ANY SERVICING
OTHER THAN THAT CONTAINED IN THE
OPERATING INSTRUCTIONS, UNLESS
QUALIFIED TO DO SO.
To Next Page
Loading...
Need help?
General
