75
8514-300-001 REV PR
7.4.5 Temperature Pricing
The Temperature Pricing option allows for the user to prompt the customer for varying vend
prices based on the water temperature the customer selects. If a value other then 0 is
programmed for either the “WARM ADDER” or “HOT ADDER”, the feature becomes active. The
programmed value is added to the base vend price when that particular water temperature is
chosen.
When the customer adds coins to meet the adjusted vend price and starts the washer, the
temperature selections available to the customer are limited to those with vend prices equal to
or less than the amount entered.
Figure 7-46 Top Level Temperature Prices Menu
7.4.6 Cycles
This option allows the user to set the bath time and spin time for the “Wash” bath. It also
allows the user to set bath time, water temperature and spin time for “Rinse” and “Final rinse”
baths. (Water temperature for the “Wash” bath is chosen by the customer using the “Hot”,
“Warm” and “Cold” buttons on the front of the machine). For the “Final Spin” it also allows the
user to set the spin speed (see additional description below).
1. “Final Spin” is the spin that occurs after all selected baths & intermediate spins
have been completed. It is a higher spin speed than previously occurring
intermediate spins. The benefit of this higher spin speed is that more water is
extracted from the wash load, which minimizes the drying time needed.
However, in some cases, if the Dexter installation guidelines are not followed
properly, it may be necessary to reduce the spin speed of the “Final Spin”.
The “Final Spin” can be adjusted in increments of 10 G for washers with a 100G
maximum spin speed and increments of 20 G for washers with a 200G maximum spin
speed. The factory default “Final spin” speeds are the maximum values.
To Next Page
Loading...
Need help?
General
