84
8514-300-001 REV PR
7.4.9 Usage
The Usage menu allows for the user to track data about machine usage. See below for detailed
information on each sub menu option.
1. “Coin Audit”: The coin audit field shows the accumulation of coin pulses that were sent
to the control over each of the left and right coin inputs. Note that this is a count of coin
pulses, not an accumulated report of vend value.
a. The user can also return the coin audit amounts to the factory default setting
(zero). To reset all coin audit values, press “Enter” when the “DEFAULT” prompt
is shown. Press “Enter” again when the “RESET” prompt is shown to confirm the
action.
2. “Cycle Count”: The cycle count field shows the accumulation of wash cycles that have
occurred. Note that this is a count of cycles, not of hours accumulated. The user can
also set the count value to a designated number. For example, if it is necessary to
replace the control on a machine, the new control could be programmed to show the
cycle count value that was recorded by the previously installed control. The individual
digits of the count can be set by using the “Up” or “Down” buttons to change the
number that is flashing. Once the desired digit of the count is chosen, press the “Enter”
button to move to the next digit. Once the complete count is chosen, the “Enter” button
must be held down for 3 seconds to confirm the action.
a. The user can also return the cycle count to the factory default setting (zero). To
reset the cycle count, press “Enter” when the “DEFAULT” prompt is shown. Press
“Enter” again when the “RESET” prompt is shown to confirm the action.
3. “Motor Hours”: The motor hours field shows the accumulated hours of operation for the
motor. In many cases, it will match the cycle hours of the machine. However, separate
fields are provided in the event that a motor is replaced on a machine. The user can set
the motor hours to a designated number. For example, if it is necessary to replace the
control on a machine, the new control could be programmed to show the motor hours
that were recorded by the previously installed control. The individual digits of the hours
count can be set by using the “Up” or “Down” buttons to change the number that is
flashing. Once the desired digit of the hours is chosen, press the “Enter” button to move
to the next digit. Once the complete hours are chosen, the “Enter” button must be held
down for 3 seconds to confirm the action.
a. The user can also return the motor hours to the factory default setting (zero). To
reset the motor hours, press “Enter” when the “DEFAULT” prompt is shown.
Press “Enter” again when the “RESET” prompt is shown to confirm the action.
4. “Cycle Hours”: The cycle hours field shows the accumulated hours of operation for the
washer. In many cases, it will match the motor hours of the machine. However,
separate fields are provided in the event that a motor is replaced on a machine. See the
Motor Hours description for more information.
To Next Page
Loading...
Need help?
General
