73
8514-300-001 REV PR
7.4.2 Vended Washer Oponal Cycles
This option allows the user to select the different test and short-cycle options.
1. “Quick Test” will begin a shortened wash cycle without the displayed vend price being
met. The purpose of this shortened cycle is to test all major components for proper
operation.
Error Codes should all function normally during this test. The display will show customer
prompts in a similar way to a normal wash cycle. Exceptions to this are that the “ADD
BLEACH” prompt will not occur because of reduced cycle time. Final Extract speed is
specific to the customer’s programming.
2. “Rapid Advance” is similar to Quick Test, in that when this option is chosen, the washer
will begin a wash cycle without the displayed vend price being met. However, in this
case, it will be a normal default cycle with an additional feature available. The “Start”
button LED will flash, prompting the user that, when pressed, the washer shall rapid
advance to the next step in the cycle. The display will show “ADVANCE” when the cycle
is advancing. The water level needs to be empty before this advance occurs. During the
time waiting for the tub to empty, the “ADVANCE” prompt will be held on the display
and the start pushbutton LED stops flashing. The Rapid Advance shall allow the tub to
empty of water and the tub to stop before beginning either spin or the next bath.
The Rapid Advance mode can be exited by pressing the programming button. This will
end the cycle. When the Rapid Advance mode is used, the cycle time will no longer be
correct. By skipping steps with Rapid Advance, the door may not open immediately at
the end of the cycle.
3. “Final Rinse and Spin” will begin only the Final Rinse Bath and Final Spin portions of the
cycle without the displayed vend price being met. The configured temperature, cycle
times, and spin speed for the Final Rinse Bath and Final Spin settings will be used when
this option is selected. Error Codes should all function normally during this test.
4. “Clean Drum” will begin a shortened cycle without the displayed vend price being met.
The cycle will be a 3-minute cycle (no spin). Hot water fill will be used, and the
detergent and softener compartments will both be flushed. Error Codes should all
function normally during this cycle.
To Next Page
Loading...
Need help?
General
