87
8514-300-001 REV PR
7.4.13 Vended Washer Rapid Advance Mode
Rapid Advance mode may be manually entered by pushing and holding the cold-water
temperature button and then pushing and holding the programming button on the controller for
three seconds. There will be no observed change to the washer or the display. The Rapid
Advance mode can be entered from either the idle mode or during the cycle. To rapid advance
to the next step in the wash cycle, push the start button. The display will show “ADVANCE”. The
washer will advance to the next bath segment. The water will drain before the advance occurs.
The Rapid Advance mode will not end until the final bath segment is completed. The final
segment cannot be skipped in Rapid Advance mode.
Notes:
1.When the Rapid Advance mode is used, the cycle time will no longer be correct.
2.By skipping steps with rapid advance, the door may not open immediately at the end of the
cycle.
7.4.14 Vended Washer Water Level Adjustment
The water level of all baths can be adjusted by changing the switch settings on the electronic
pressure sensor. Vended washers are shipped with the pressure sensor harness connected to
Switch #1 and factory set for an energy-efficient water level. Switch #2 is factory set for the
classic water level. To use Switch #2, move the org/yel wire from the terminal marked 21 to
the terminal marked 31 and move the red wire from the terminal marked 22 to the terminal
marked 32.
Water level adjustments can also be made in 6.35mm (1/4”) increments by adjusting the switch
positions for the desired level. It is not recommended for the water level to be set above the
factory Switch #2 settings. Refer to the following chart for the switch settings and the factory
default settings:
To Next Page
Loading...
Need help?
General
