About the development board
The development board supports the ConnectCore for i.MX51 module. This section describes the
interfaces of the development board and explains how to configure the board for your requirements.
The development board has two 180-pin connectors that mate with the module connectors.
About the development board 65
Switches and push-buttons 67
Jumpers 71
LEDs 73
Power LEDs, LE3, LE4, LE6 and LE7 73
Audio interface 75
Coin cell battery 77
Camera interfaces 78
Digital IO interface 80
Ethernet 1 interface 81
Ethernet 2 interface 83
HDMI interface 85
I2C interface 87
JTAG interface 89
LCD interfaces 90
MicroSD™ card interface 95
Module connectors and signal rails 97
J25 pinout 98
J26 pinout 100
Peripheral application header 104
Power-Over-Ethernet (PoE) - IEEE802.3af 106
Main power connector 108
SD-card interface 109
SPI interface 111
UART interface 113
USB host interface 116
USB OTG interface 117
User interface 118
Analog video interface 119
WLAN interface 121
Digi XBee interface 123
ConnectCore for i.MX51 Hardware Reference Manual
64
To Next Page
Loading...
Need help?
General
