About the development board Camera interfaces
ConnectCore for i.MX51 Hardware Reference Manual
78
Camera interfaces
The development board provides two camera interfaces connected to the camera sensor interfaces of
the ConnectCore for i.MX51 CPU. The I2C bus of the ConnectCore for i.MX51CPU is used to configure
and control the two cameras.
The I2C device addresses of the Digi camera application kits (CC-ACC0MT9V111) are the following:
Interface
I
2
C Address (7 bits)
Camera 1 0 x 5C
Camera 2 0 x 48
Two 2 x 10 pin headers, X15 and X17, are provided on the development board for connecting two Digi
camera application kits (optional) or customer specific hardware.
n X15 connector for camera 1
n X17 connector for camera 2
To Next Page
Loading...
Need help?
General
