Command descriptions set user
ConnectPort® LTS Command Reference
153
set user
Purpose
Used to:
n Add users for access to a ConnectPort LTS product. Up to 32 users can be defined.
n Associate a user with up to two groups. A user can be associated with up to two groups.
n Disassociate a user from a group.
n Remove users.
n Change user settings.
n Display user settings.
n Load an SSH public key.
Required permissions
For products with two or more users, to use this command, permissions must be set to one of the
following:
n For a user to display user configuration attributes:
“set permissions s-user=read”
n For a user to display and set user configuration attributes:
“set permissions s-user=rw”
See "set permissions" for details on setting user permissions for commands.
Default permissions for a new user
When a new user is created, it is given a set of default permissions. Once a user is created, an
administrator can adjust permissions up or down as needed. Default permissions for a new user are
as follows. For more information on user permissions, see "set permissions."
n none: backup, boot, buffers, connect, display, filesys, kill, revert-all, s-alarm, s-pmodem, s-
snmp, status, s-trace, s-profile, ping, python, s-internalmodem,s-lcd, s-modem, s-ppp, s-
portauth,
s-python, s-serial, s-sdmemory, s-sysauth, s-socket_tunnel, s-term, s-usb, s-xbee, webui
n execute: reconnect, rlogin, telnet, who
n read: s-host, s-permissions, s-ethernet, s-group, s-network, s-serial, s-service, s-system, s-user
n r-self: s-autoconnect, s-rtstoggle, s-tcpserial, s-udpserial
n rw-self: newpass
Syntax
Add a user
To Next Page
Loading...
Need help?
General