Digi ConnectPort LTS8 Command Reference

Command descriptions set ippool
ConnectPort® LTS Command Reference
65
set ippool
Purpose
Creates a pool of IP addresses for serial ports and internal modem, or displays the currently defined
pool of IP addresses. This command can be used for configuring IP addresses for PPP connections.
Required permissions
Permissions must be set to “set permissions s-ppp=read” to display ippool configuration settings, and
“set permissions s-ppp=rw” to display and set ippool configuration settings. See "set permissions" on
for details on setting user permissions for commands.
Syntax
Change ippool configuration settings
set ippool [state={off|on}]
[count=1-32]
[ip= ip address ]
Display current ippool settings
set ippool
Options
state={on|off}
Specifies whether the ippool will be enabled
on
Enable the ippool.
off
Disable the ippool.
count=1-32
Specifies the number of IP address in the pool. Maximum number of IP address in the pool is 32.
ip=ip address
The first IP address in the pool.
Example
Specify 32 IP address pools
#>set ippool state=on count=32 ip=192.168.100.1
See also
set ppp

Digi ConnectPort LTS8 Specifications

General

Brand	Digi
Model	ConnectPort LTS8
Category	Server
Language	English