Select Models for the Preset’s Channels
In the previous steps, we selected a Tweed for the Green Channel and a Rectified Model for the Red
Channel.Then we Warped the two together to create our HyperModel™.This HyperModel™ is saved as
an amp type that we named Rectweed,but it is not currently part of our preset.In this example preset,
we need to be able to toggle between an acoustic guitar simulation and our new HyperModel™.To do
this we need to select the Acoustic model for the Green Channel and Rectweed for the Red Channel of
our preset.The LED next to the Status button should be yellow. If it is not, press EXIT.Now rotate the
Number 1 knob until the display reads
ACOUSTic.This is the Green Channel Model for the preset.
Rotate the Number 4 knob until the display reads
RECTWeeD (our new HyperModel™).This is the Red
Channel Model for the preset. This lets us toggle between these two sounds using the Amp Footswitch
(when FX Mode is active).
Edit the Preset
The next step to creating our example preset requires entering the Effect Edit mode.To do this, press
the EFFECT SELECT DOWN button. The Matrix LED in the Wah-Pickup row lights. The display
briefly reads EDIT and then cycles between the status of the Wah and Pickup Simulator effects.If the
red display reads on WAH On,press the STATUS button once to turn it off (since our example is not
using a Wah).
Select the Pickup Type
In our example preset we are using a single coil pickup,but want it to sound like a double coil hum-
bucker. With the Wah-Pickup LED lit, rotate the Number 4 knob until the display reads SC>Humb.
This makes a single coil sound like a Humbucker.
32
Tutorial
To Next Page
Loading...
Need help?
General
