Turn the Delay Off
In our example preset we want to bypass the Delay. Press the EFFECT SELECT DOWN button
again and the LED in the Delay row will light. If the display reads on (On),press the STATUS button
until the display reads off (Of).
Select and Adjust the Reverb
In our example preset we wanted a little bit of Hall Reverb to provide some ambience. Press the
EFFECT SELECT DOWN button again and the LED in the Reverb row lights. If the display reads
off (Of),press the STATUS button until the display reads on (On). Rotate the Number 1 knob to
select Hall (Hall) for the Reverb Type. Rotate the Number 2 knob to set the Reverb Predelay to 2.
Rotate the Number 3 knob to set the Reverb Decay to 15. Rotate the Number 4 knob to set the
Reverb Damping to 40. Rotate the Number 5 knob to set the Reverb Level to 30.
Store the Preset
The last step, is to store our changes to a User Preset. If we changed presets or turned the GNX2
off without storing these settings,it would forget what we had done and revert back to the original
preset.To store the preset,press STORE. The first letter in the Display begins to flash. Since this is
an example preset,let’s name the preset examplE.Rotate the DATA WHEEL until the flashing
character in the display is an E.Press the RHYTHM button once and the second character begins
to flash.Use the Data Wheel again until the flashing character is an X.Continue using the Rhythm
button to select the character location and the Data Wheel to change the characters.
35
Tutorial