Adjust the Noise Gate
For our example,we want our Noise Gate to open quickly with a relatively weak signal.This type of
gate uses the Silencer™ with a low Threshold and short Attack Time. Press the AMP
FOOTSWITCH to select the Red Amp Channel. Press the EFFECT SELECT DOWN button
and the Noise Gate’s LED lights. If the display reads off (Of),press the STATUS button until the dis-
play reads on (On). Rotate the Number 1 knob until the display reads SILeNCeR for the type of
gate. Rotate the Number 2 knob to set the Threshold to 20 (this may need to be adjustment depend-
ing upon your guitar).Rotate the Number 3 knob to set the Attack Time to 0 (fast attack).
Turn the Talker™ Off
In our example preset we don’t want the Talker™ effect to be used. With the Gate - Talker LED lit,
rotate the Number 4 knob until the display reads talk off.This will turn off the Talker™.
Select and Adjust the Chorus
Next we wanted to thicken up the sound in our preset by adding a subtle Chorus effect. Press the
EFFECT SELECT DOWN button again and the LED in the Chorus/Mod row lights. If the display
reads off (Of),press the STATUS button until the Display reads on (On). Then rotate the Number 1
knob until the display reads Chorus(Chorus) for the effect type. Rotate the Number 2 knob to set
the Chorus Speed to 5. Rotate the Number 3 knob to set the Chorus Depth to 30. Rotate the
Number 5 knob to set the Chorus Level to 50.
34
Tutorial
To Next Page
Loading...
Need help?
General
