Grn GAIN (Green Gain) - Controls the Amp Gain for the Green Channel.
Gnr LEVL (Green Level) - Controls the Volume of the Green Channel.
Red GAIN (Red Gain) - Controls the Amp Gain for the Red Channel.
Red LEVL (Red Level) - Controls the Volume of the Red Channel.
GATTHRes (Gate Threshold) - Controls the Noise Gate’s Threshold.
GATAtTaK (Gate Attack) - Controls the Noise Gate’s Attack time.
PLKSNS (Gate Pluck) - Controls the Noise Gate’s Pluck Sensitivity.
Modulation Effects Parameters
Active Effect
Chorus
Speed Depth PreDly MOD Bal MOD LVL
Flanger Speed Depth Regen MOD Bal MOD MIX
Phaser Speed Depth Regen MOD Bal MOD MIX
Triggered Flanger Speed Senstv LFO St MOD MIX
Triggered Phaser Speed Senstv LFO St MOD MIX
Tre molo Speed Depth
Panner Speed Depth
Vibrato Speed Depth
Rotary Speaker Speed Depth Doppler crosover MODBAL MOD MIX
Auto Ya™ Speed Depth RANGE MOD Bal MOD MIX
YaYa™ YA PDL Depth RANGE MOD Bal MOD MIX
SynthTalk Attack Release Vox MOD Bal Senstvty
Envelope Filter Senstvty Range MOD Bal MOD MIX
Detune Amount MOD Bal MOD LVL
Pitch Shift SHIFT MOD Bal MOD LVL
DLY FdBK
(Delay Feedback) - Controls the amount of Delay Feedback.
DUKTHRes (Delay Threshold) - Controls the Ducker Threshold for the Delay.
DUk AtTN (Ducker Attenuation) - Controls the attenuation level applied to the Delay signal when the
Ducker Threshold is exceeded.
DLY LeVL (Delay Level) - Controls the Mix Level of the selected Delay Type.
DLY BAL (Delay Balance) - Controls the left/right balance of the selected Delay Type.
RVB PRE (Reverb Predelay) - Controls the Reverbs Predelay time.
RVBdecay (Reverb Decay) - Controls the Reverbs Decay time.
RVB LeVL (Reverb Level) - Controls the Reverbs Mix Level.
RVB BAL (Reverb Balance) - Controls the left/right balance of the selected Reverb Type.
VOL PRE (Volume Pre) - Controls the Volume after the Amp Modeling but before the Effects.
VOL PoST (Volume Post) - Controls the Volume at the end of the Effects chain.
LFo1 SPD (LFO 1 Speed) - Controls the modulation speed of Expression LFO 1.
LFo2 SPD (LFO 2 Speed) - Controls the modulation speed of Expression LFO 2.
Utilities
The Utility section contains all of the menus for assigning global functions to the GNX2. Global functions
affect the GNX2 in its entirety rather than on a per preset basis.The Utility menus include:Mono/Stereo
Output,Target System Setup,Volume Pedal Update,V-Switch Threshold,Expression Pedal Calibration,Dry
Track Enable, Bank Naming,MIDI Channel, MIDI Sysex Dumps,Amp Dumps,MIDI Mapping,MIDI Merge, and
Factory Reset.To enter the Utility section,press the Utility button. Once in the Utility menu,the Rhythm
button selects the next menu (scrolls to the right), and the FX Mode button selects the previous menu
(scrolls to the left). Each of these Utility menus is described in more detail in the following pages.
39
Other Functions
To Next Page
Loading...
Need help?
General
