Changing Oil Filter
Refer to engine manual.
Spark Plugs
Removing, checking and cleaning spark plugs
(petrol only) - refer to engine manual.
Fuel Filter
Replace the fuel lter after every 100 hours or
yearly, whichever occurs rst.
1 Never reinstall a dirty lter.
2 Lower the Dingo arms and turn the ignition key
to OFF to stop the engine. Remove the key.
3 Turn fuel tap off (by turning clockwise) to
block fuel ow. (Tap on diesel is lever on lter
and will be in horizontal position when off, tap
on petrol models is a knob on the petrol tank and
should be tightened to close / turn off).
4 Squeeze the ends of the hose clamps together
and slide them away from the lter.
5 Place a drain pan under the fuel line to catch
any spillage, then remove the lter from the
fuel lines.
6 Install a new lter and move the hose clamps
close to the lter.
7 Remove clamp blocking fuel ow.
Draining the Fuel Tank
DANGER! Petroleum can be extremely
ammable and highly explosive. To avoid a
re of explosion that may burn yourself, others,
or cause property damage:-
• Drain petrol from the fuel tank when the engine
is cold. Do this outdoors in an open area.
• Wipe up any petroleum that spills.
• Never drain petroleum near an open ame or
where a spark may ignite petroleum fumes.
Note: Dispose of used oil in accordance with
local authority regulations.
7 Slowly pour approximately 80% of the spec-
ied amount of oil (refer to engine manual) into
the ller tube. Now check the oil level. Slowly
add additional oil to bring to FULL mark on
dipstick.
1. Hydraulic Filter
2. Gasket/O Ring
3. Adapter
Hydraulic System
Replacing the Hydraulic Filter
Change the hydraulic lter after every 500 oper-
ating hours.
IMPORTANT: Do not substitute with
automotive oil filter or severe hydraulic
damage may result.
1 Position the Dingo on a level surface, lower
the arms and turn the ignition key to OFF to stop
the engine. Remove the key.
2 Remove the bonnet and side panels
3 Remove the old lter and wipe the lter adapter
gasket surface clean.
4 Apply a thin coat of hydraulic uid to the
rubber gasket on the replacement lter.
5 Install replacement hydraulic lter. Tighten
clockwise until the rubber gasket contacts the
lter adapter, then tighten the lter an additional
1/2 turn.
6 Clean up any spilt uid.
• Never smoke while handling fuel.
1 Park the Dingo on a level surface, to ensure
fuel tank drains completely.
2 Lower the Dingo arms and turn the ignition key
to OFF to stop the engine. Remove the key.
3 Loosen the hose clamp at the fuel lter and
slide it up the fuel line away from the fuel l-
ter.
4 Pull the fuel line off the fuel lter, open the
fuel valve, and allow fuel to drain into a fuel
can or drain pan.
5 Remove tank, drain completely and ush by
tipping tank upside down.
6 Reverse procedure to replace clean tank.
NOTE: Now is the best time to install a new fuel
lter because the fuel tank is empty.
7 Install the fuel line onto the fuel lter.
8 Slide the hose clamp close to the fuel lter to
secure the fuel line.
To Next Page
Loading...
General