Operating on Slopes
All slopes require extra caution.
n Do not operate on slopes exceeding 15
degrees. If a slope is greater than 5 degrees, only
go up and down (not across).
n Always have the heavy end of the
machine uphill. Weight distribution will
change. An empty bucket will make the rear
of the machine heaviest, a loaded bucket will
make the front of the machine heaviest. Various
attachments will change which end is heaviest.
If you are unsure, phone us and ask. These
same rules apply when loading and unloading
the Dingo onto a trailer or truck.
n Avoid turning on slopes. If you must
turn, turn slowly keeping the heavy end of the
machine uphill.
n Do not operate near ditches or
embankments, the machine could turn over if
a wheel goes over the edge of a cliff or ditch or
the edge caves in.
n Do not operate on wet grass, reduced
traction could cause wheel slip.
n Remove obstacles such as rocks, tree
limbs, etc from the work area. Watch for ruts
or bumps as uneven terrain could overturn the
machine. Tall grass can hide obstacles.
n Operate in slow speed. Put pump selector
valve in slow (turtle) position so that you will
not have to stop or shift while on the slope.
n If parking on slopes or hillsides always
lower the Dingo arms and attachment to the
ground and chock the wheels.
n If machine becomes unstable, jump clear.
Never try to stabilise the machine by putting
your foot on the ground.
Children
n Be wary of the presence of children when
operating a Dingo. Children are often attracted
to the Dingo and the work activity.
n Keep children out of the work site and
under the watchful care of a responsible adult.
n Be alert and turn the machine off if
children enter the area.
n Never carry children (or anyone) on the
Dingo or any of its attachments.
n Do not allow children to play on the
Dingo or within the Dingo work site (aside from
the danger of working machinery there may be
holes into which a child could fall or various
other dangers).
n Do not allow children to use the
machine.
n Before reversing look behind and down
for small children. Be aware of blind corners,
shrubs, trees, or ends of fences that may obscure
vision.
Service
n Before performing any service, repairs,
maintenance or adjustment, stop the engine and
remove the key.
n Never run the machine in an enclosed
area.
n Perform all maintenance with the Dingo
arms fully lowered. If Dingo arms need to be
raised to perform tasks, secure them in the raised
position by using cylinder locks or a safety
stand. (Contact a Dingo representative if you
are unsure)
n Look after the Dingo. Keep nuts and
bolts tight.
n Do not tamper with safety devices. Before
each use check safety systems properly.
To Next Page
Loading...
General