Dingo K9-4 Operation & Maintenance Manual
8
Dingo K9-4 Operation & Maintenance Manual
9
Operation -
Pre Start-Up
Pre Start-Up (daily)
Read this manual and the engine manual and
become familiar with the contents of both.
Always check the following before
operation:
• Fuel level - ll to 60mm from top
• Engine oil level (refer to engine manual)
• Remove all refuse from the machine
• Check air lter
• Check bushes
• Tyre pressure (25 - 35psi)
• Radiator - check/clean . Check uid (diesel
only)
• Check for oil leaks
• Check for damage & loose components
• Be sure that the work area is free from other
people and children
• Clean work area of any debris
• Know and mark the location of any utility
lines
• For rst 6 days of operation of new machine,
and rst 6 days of operation after changing
wheels, tighten wheel nuts daily.
Adding Fuel
Labelling on the fuel tank tells whether a machine
requires petroleum of diesel fuel. For fuel type
and information on suitable additives refer to
Engine Manual as supplied. (NB. If labelling
becomes lost or damaged order replacements
from your Dingo representative).
1 Position Dingo on level surface, lower the
Dingo arms and turn off the engine (turn ignition
key to off). Remove the key.
2 Remove the bonnet to expose the fuel tank
cap.
3 Clean around the fuel tank cap and remove the
cap. Use a funnel to add fuel to the fuel tank,
lling until the fuel reaches 60 - 70 mm below
the top of the tank. This space is needed to allow
the fuel room to expand. Do not ll the fuel tank
completely full.
4 Replace the fuel cap securely. Clean away any
fuel that may have spilt.
DANGER - Petroleum can be extremely
ammable and highly explosive.
To avoid a fire or explosion that may burn
yourself, other, or cause property damage:-
• Use a funnel and ll the fuel tank outdoors, in
an open area
• Allow the engine to cool before refuelling
• Clean up any petrol spills.
• Only ll to 60 mm from top of tank.
• Never smoke while handling fuels, and stay
away from an open ame or any place that a
spark may ignite petroleum fumes.
• Store fuels in an approved container, out of
reach from children. Never buy more than a 30
day supply of fuel.
Checking the engine oil
Check the engine oil level using the dip stick.
(Refer to your engine manual for details)
Remove Debris from the
Machine
IMPORTANT: Overheating will result if the
engine is operated with a blocked grass screen,
dirty or plugged cooling ns, and/or cooling
shrouds removed.
The hydraulic system will keep cooler if the
machine is free from debris on the hydraulic
tank and ttings.
Park the machine on a at surface, lower the
Dingo arms and turn off the engine. (turn ignition
key to off). Remove the key.
Check air lter pre-cleaner for debris. If required,
wipe away debris before and during each use.
Debris can build up in the engine area. Remove
sides of engine bay and clean any debris build-up
with a brush or blower before each use.
IMPORTANT: It is preferable to blow out dirt
than to wash it out. If water is used, keep it away
from electrical appliances.
To Next Page
Loading...
General