3. MAINTENANCE
3.1 Engine Disassembly
3.1.1 Heed at disassembly
·Before disassembly, the part shelf should be prepared for various tools and repair parts.
·When assembling, clean empty hand should be used and clean environment maintained.
·In case of storing the disassembled parts, each part should not touch each other.
·In case of disassembly, the parts should be laid in order.
3.1.2 Oil level gauge
·Pull out the oil level gauge.
3.1.3 Cooling water
·Remove the radiator cap. Open the drain plug at the radiator lower part to drain the coolant as the right
figure.
Caution:
When removing radiator filler cap while the engine is
still hot, cover the cap with a rag, then turn it slowly
to release the internal steam pressure. This will
prevent a person from scalding with hot steam
spouted out from the filler port.
·Remove the drain plug from the cylinder block and drain
out the cooling water into a container.
To Next Page
Loading...
Need help?
General
