3.1.40 Bearing cap
·Remove the bearing cap assembling bolts by the step in
the reverse order of assembling, and disassemble the
bearing cap. (Remove by the same way as the cylinder
head bolts’ removal.)
·Disassembled bearing caps are kept laid in order.
3.1.41 Crankshaft
· Assemble the bolts on the both side of crankshaft
temporarily.
·Connect the rope to the bolts and lift the crankshaft by
means of crane being careful not to give any damage on
it.
·In order for the disassembled crankshaft to be prevented
from bends or damage, put it on the special lathe and
store.
·Disassemble the metal bearings in turn and store them.
Note:
Do not mingle with the metal bearings and bearing
caps randomly. To prevent mixing, temporarily
assemble the metal bearings to the corresponding
bearing caps in turn.
3.1.42 Camshaft and tappet
·In order for camshaft not to be damaged, disassemble
turning it.
·In order for the disassembled camshaft to be prevented
from bends or damage, put it on the special lathe and
store.
·Pull out the tappet.
·As required, pull out the camshaft bush from the cylinder
block by a press.
· Check for damage, scratch, wearing state and if
abnormal, tear down.
To Next Page
Loading...
Need help?
General
