· When the connecting rod bearing cap bolts are
tightened, check the connecting rod end play to the
right and left with hand. If no end play is found,
remove and reinstall or replace the connecting rod
bearing cap.
3.3.13 Timing gear case
·Mount a new gasket using dowel pin on the cylinder
block.
·Put the time gear case to the cylinder block by aligning
the dowel pin hole of timing gear case with its pin, and
then assemble it by tapping lightly with an urethane
hammer to the right and left (Particularly around dowel
pin).
· Tighten the bolts for assembling to the specified
torque. However, in case of tightening the bolts,
tighten primarily the bolts of both end parts and then
do the rest.
3.3.14 Timing gear and idle gear pin
·Install the oil pump idle gear onto the No.7 bearing
cap.
· Install a thrust washer over the camshaft and
assemble the cam gear by aligning it with camshaft
dowel pin. Tighten the cam gear assembling bolts to
the specified torque. (Zigzag method)
To Next Page
Loading...
Need help?
General
