Field Alarm Description
System alarm Probe alarm, Strapping table alarm, Wrong offset alarm (mm<0), Out of Scale alarm
Tank alarm High-high product, High product, Low product, Low-low product, Water
Delivery End of delivery report
Leakage Leakage detected
Stock Inventory report
Shift Shift report
Sudden loss Sudden loss report
Sensor Sensor alarm
Click Save when you complete the Notifications tab configuration.
6.3 Tank Setup Menu
1. Select Tank setup from the Main Menu. The number of Tanks configured in "Site Info" on
page19 will show in the Tabs bar.
2. Select a Tank to configure.
3. An information bar below the tabs bar will show the Height and Max Volume of the selected tank.
This is read-only data from the last line of the tank strapping table ("Straptable" on page36).
6.3.1 Settings
4. The bar below the information bar shows the configuration parameter selections. Settings is the
first selection.
a. Move the Enabled swipe button to ON to let the application query the installed probe
during the read cycle. A probe query does not occur if this button is OFF.
b. Serial: This is the Probe address (if it is incorrect, there will be no reading).
M2051-EU Rev.: 1 Dover Fueling Solutions
Page 31
To Next Page
Loading...
Need help?
General
