08
170
In the event of a breakdown
If after 7 minutes the pressure of 2 bars is
not reached, this indicates that the tyre is
damaged; contact a dealer or a qualified
workshop for assistance.
F
Once the correct pressure is reached, put
the switch in position "O".
F Remove the kit and stow it.
Should the pressure of one or more tyres
be adjusted, it is necessary to reinitialise
the under-inflation detection system.
For more information on Tyre under-
inflation detection, refer to the
corresponding section.
Spare wheel
Scan the QR Code on page 3 to view
explanatory videos.
For more information on the Tool kit, refer
to the corresponding section.
Access to the spare wheel
The spare wheel is stored under the boot
carpet.
The spare wheel is a "space-saver"
wheel.
Removing the spare wheel
F Slacken the central nut.
F Remove the fastening device (nut and bolt).
F Lift the spare wheel towards you from the
rear.
F Take the wheel out of the boot.
Putting the spare wheel back in
place
The punctured wheel cannot be placed in
the boot under the floor.
F
Tighten the central nut sufficiently to retain
the wheel correctly.
F Depending on version, store the tool box in
the middle of the wheel and clip it in place.
F Put the wheel back in place in its housing.
F
Slacken the nut on the bolt by a few turns.
F
Position the fastening device (nut and bolt)
in the middle of the wheel.
To Next Page
Loading...
Need help?
General
