DSC Neo Power HS2016 User Manual

Chapter 3
4. After successfully initiating the setting sequence the:
l
Set indicator turns on.
l
Ready indicator remains lit.
l Exit Delay timer begins counting down.
l Keypad beeps six times, continues beeping once per second until beeping rapidly
in the final ten seconds.
l The system may be configured to have a persistent exit delay that only ends when
the exit door is opened and closed, or when a button is pressed outside the pro-
tected premises.
Exit Delay in
Progress
5. To cancel the setting sequence, enter your [access code] or present your proximity
tag to the keypad reader.
System Disarmed
No Alarm Memory
6. Once the exit delay timer expires, thereby setting the system, the:
l Ready indicator turns off.
l Set indicator remains on.
l Keypad stops sounding.
System Armed
in Away Mode
Note:The installer configures the exit delay timer and whether or not an access code is required for setting the system.
3.2 Night Setting the System with the Keypad
Night mode partially activates the alarm system by:
l Bypassing all internal sensors configured as Night zones.
l Setting all perimeter sensors.
l Setting all other internal sensors.
Setting the system in Night mode is possible after the system has first been set in Stay mode and [*][1] is pressed at the keypad.
The keypad can also be configured with a function key to set the system in Night mode. To access set interior areas when the sys-
tem is set in Night Mode, you must unset the system.
Note:Ensure that your installer has provided you with a list identifying all programmed night zones. Your installer can configure a
function key to set the panel in Night mode without the system already being set in Stay mode.
To Set the System in Night mode LCD Display
1. If configured, press and hold the Night Set key for 2 seconds.
OR
2. Once the system is set in Stay mode (Set indicator is on) at any keypad press [*]
[*].
OR
press[*][1].
Date Time
JAN 02/13 2:06a
then
Press (*) for <>
Interior Arm
3. If required, enter your [access code]. All interior zones will now be set, except for
devices programmed as Night Zones.
l
The Night mode icon turns on.
Present Tag or
Enter Code
then
Interior Has
Been Armed
To gain access to interior areas that are set during Night mode unset the system by entering your [access code].
3.3 No-Entry Setting
No-Entry Setting sets the system in Stay mode by:
l Removing the Entry Delay from all configured zones.
l Setting all perimeter sensors.
l Bypassing all interior sensors.
An entry through any zone will create an instant alarm.
To No-Entry Set the System LCD Display
- 8 -

DSC Neo Power HS2016 Specifications

General

Brand	DSC
Model	Neo Power HS2016
Category	Security System
Language	English