38
13. CROSS FOLDING
Cross folding is folding single-folded paper
another time as shown in the figure. Many
cross folding styles are available according to
settings.
<Single folding>
<Cross single folding>
<Cross brochure folding>
∑ dent
13-1. Cross Folding Methods
The following three cross folding methods are
available on this unit.
(1) Cross folding of standard paper
Standard paper consists of five types LGR, LGL,
LTR, STMT, and INV (short edge feeding of paper)
and is paper whose size can be automatically
detected.
(2) Cross folding of non-standard paper
Non-standard paper is paper other than standard
paper specified by this unit. It is paper within the
following size range.
( ) shows the minimum foldable size under
conditions given.
Paper
Paper feed direction
Length: 7.2" (5.1") to 17.0"
Width: 5.1" (3.0") to 11.7"
(3) Cross folding of paper at desired
folding position
This is the cross folding of standard and non-
standard paper at the desired folding position.
Both standard and non-standard paper are
processed in the same way, and the folding
position is registered in the custom folding mode.
13-2. Precautions on Cross
Folding
Pay attention to the following in cross folding.
The maximum thickness of paper used is
28 lb.
The maximum thickness depends on conditions such
as using environment (temperature, humidity), paper
size, paper type, paper grain direction, paper printing
state, etc.
Press along the folded line of single-
folded paper with the fingers.
If the folded line is not folded properly, paper feed will
be unstable.
Paper ∑ dent and folding misalignment along the
sides of the paper may occur if the folded line of
single-folded paper is not folded properly or
according to the using environment
(temperature, humidity), paper thickness, paper
size, paper type, paper grain direction, etc. This
is not a malfunction of the unit.
NoteNote
To Next Page
Loading...
Need help?
General
