43
-1 1 2 3 4 5 6
0
6
0
1
2
3
4
5
6
15. USING SPECIAL PAPER
15-3. Folding Small Size Paper
Paper size ranges within 5.1" to 7.1" in length and 3.0" to 5.0" in width (fed by short edge feeding)
can be folded in the following conditions.
Paper size ranges within 5.1" to 5.5" in length and 3.0" to 4.2" in width can only be single folded
or brochure folded.
Paper size ranges within 5.6" to 7.1" in length and 4.3" to 5.0" in width can be single folded, letter
folded, accordion folded, and brochure folded, but not double folded and irregular accordion
folded.
SeeSee
When the folding mode key is pressed, the lamps of unselectable folding modes will be skipped without
lighting.
Paper within the above size ranges are non-standard paper. As the automatic paper size
detection function does not work for these paper sizes, there is a need to register the paper
length.
“11. STANDARD FOLDING OF NON-STANDARD PAPER” (
☞
p.32)
The thickness of paper which can be used ranges from 16 to 20 lb.
Stack paper on the paper feed tray after fanning it well. However, stack less than usual, within a
stacking height of 1.4".
Do not set the maximum processing speed. Set as low as possible.
NoteNote
Continuous-feed occurs easily when high processing speeds are set. This is because the paper is small and
light, and is not a malfunction.
NoteNote
Set the paper feed pressure to “0” or “–1”.
Set the paper separating pressure to “0”,
and increase the value by 0.5 at a time
according to the paper feed conditions.
Top cover
Separating pressure adjusting dial
Paper feed pressure adjusting lever
To Next Page
Loading...
Need help?
General
