Eaton 9130 User Manual

Operation
Eaton 9130 700/3000 VA UPS User’s Guide 164201718—Rev 7 www.eaton.com/powerquality 33
To start the UPS on battery:
1. Press the button on the UPS front panel until the UPS front panel display illuminates and shows a
status of “UPS starting…”.
The UPS cycles through Standby mode to Battery mode. The
indicator illuminates solid. The UPS
supplies power to your equipment.
2. Check the UPS front panel display for active alarms or notices besides the “UPS on Battery” notice and
notic
es that indicate missing utility power. Resolve any active alarms before continuing. See
“Troubleshooting” on page 83.
Check the UPS status from the front panel to view the active alarms. Correct the alarms and restart if
nece
ssary.
3. Press the
ESC
button until the start screen appears.
UPS Shutdown
To shut down the UPS:
1. Press the
button on the front panel for three seconds.
The UPS starts to beep and shows a status of “UPS off pending…”.
The UPS then transfers to Standby
mode, and the indicator turns off.
NOTE Releasing the button before three seconds returns the UPS to its original
operating mode.
2. Switch off utility power where the UPS is connected.
Transferring the UPS Between Modes
From Normal to Bypass Mode. Press any button to activate the menu options, then select CONTROL and
GO TO BYPASS.
From Bypass to Normal Mode.
Press any button to activate the menu options, then select CONTROL and
GO TO NORMAL.
Retrieving the Event Log
To retrieve the Event Log through the display:
1. Press any button to activate the menu options, then select EVENT LOG.
2. Scroll through the listed events.
Logic Power Off
If normal utility power is restored within the time set by the Logic Power Off parameter, the unit restarts
automatically. If AC power is not restored within this time, the logic power turns off.
NOTE The equipment does not restart automatically when normal utility power is restored
if the unit is shut down by power shutdown management software or a connectivity
card, such as the Intelligent Power
®
Protector (IPP) or a Network Card-MS.

Eaton 9130 Specifications

General

Brand	Eaton
Model	9130
Category	UPS
Language	English