2. Installation
2.6 Programming software license
2.6 Programming software license
The programming software (version 7 and higher) is available for download.
Please note that easyE4 devices can only be programmed with easySoft 7.
The easySoft 7 programming software program is available for free. However, you will
need to buy a software license in order to be able to use all of the software's functions.
You can order an easySoft 7 programming software license through your
supplier or through the EATONonline catalog EASYSOFT-SWLIC, article
no. 197226.
http://www.eaton.eu/ecat
Once you purchase a software license, you will receive a license product certificate
that you can then use to request a license key online. This license key can be used to
unlock all of the software's functions.
Installation requirements
l An easySoft 7 version
l A PC that meets all system requirements and for which the person installing the
software has administrator privileges
l A 24-digit license key
If a valid key is not entered during installation, the software will
be installed in demo mode.
This means that the software will be fully installed, but with the
following limitations:
l You will not be able to load any programs onto a connected
device (no online function)
l There will not be any card manager functions available for
the microSD memory card
However, you will still be able to simulate programs.
You can always add a license key later on.
66
easyE4 11/18 MN050009 EN www.eaton.com
To Next Page
Loading...
Need help?
General