28
Shut down in ECO mode
1. Switch-off screen (selftest is disabled) 2. Press Enter and the following screen
will appear.
3. Select "LOAD OFF ALONE" and press
Enter, the following screen will appear.
Then press Enter to conrm.
4. Select "ECO DISABLE" and press
Enter, the system will transfer to line mode
and not enter ECO mode automatically.
COMMAND
HELP
COMMAND SELECT
LOAD OFF ALONE
ECO DISABLE
CONFIRM
LOAD OFF ALONE
NO, CANCEL
YES, CONFIRM
CONFIRM
ECO DISABLE
NO, CANCEL
YES, CONFIRM
Note: the item STATE will display UPS power supply, fault and alarm information by
turns every 1S.
1. The state screen (1), which displays
load, input voltage and state information
and so on.
Power on the UPS, then press "ESC" or do not press any key within 1 min to
automatically enter the state screen. And Press to obtain the below screens.
2. Press to obtain the below information.
OUTPUT PARAMETER
VOUT: 220.5V
IOUT: 45.5A
FREQ: 60.0Hz
LOAD: 100%
I P VOLT: 220.0V
BAT VOLT: 260V
STATE: BYPASS
3.4 Function screens
To Next Page
Loading...
Need help?
General
