SD3 Series Ultrasonic Pocket Doppler User Manual Basic Operation
- 19 -
NOTE:
If the charging indicators are flashing in red, it indicates that the batteries are defective
or non-rechargeable or that short circuit occurs.
WARNING
Make sure the batteries are not connected reversely before plugging the charger into the
power socket.
3.6.4 Charging the Doppler (SD3 PLUS, SD3 PRO)
Put the plug of the power adapter into the charge socket of the Doppler, and connect the power
adapter to a power supply socket.
During charging, a battery sign appears on the OLED with continuously changing energy sign.
When the charging indicator shows full status, the battery finishes charging. Remove the power
adapter plug and the Doppler is ready for examining again.
The specifications of the provided power adapter are as follows:
Input: AC 100-240 V, 50/60 Hz, 0.2 A
Output: DC 5 V, 1 A
3.6.5 Charging the Charge Stand
For the Doppler equipped with a charge stand, put the plug of the power adapter into the charge
socket of the charge stand, and then connect the power adapter to a power supply socket.
The specifications of the provided charge stand are as follows:
Input: DC 5 V, 1 A
Output: DC 5 V, 1 A
The specifications of the provided power adapter are as follows:
Input: AC 100-240 V, 50/60 Hz, 0.2 A
Output: DC 5 V, 1 A
The charge stand can be put on a table or fixed on the wall as below.
On a table: Put the charge stand on a flat table.
On the wall: Aim the two bracket holes in the back of the charge stand to the wall, leave two
marks and drill in the marked place. Screw in each hole and make sure the screws are fixed in the
wall. Aim the bracket holes to the screws on the wall and fix the screws in the hole and tighten
the screws.
The Doppler can be charged when placed in the charge stand.
To Next Page
Loading...
Need help?
General
