D397-50-880 Issue C
Page 10 © Edwards Limited 2010. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
Sufficient space must be provided at the rear of the unit for the cables. For this reason it is suggested that the
customer uses a straight Profibus connection. If a right-angled connection is to be used space will be required above
the height on the module.
CAUTION
Do not "Hot-swap" the DX pump connection. Power must be removed before connecting or disconnecting a turbo
pump.
CAUTION
The unit is IP30 rated. Please ensure that the unit is not installed where fluids can enter into the Controller.
3.2.1 Rack mounting
For Rack mounting the unit should fit in a 6HP wide, 3U High space using the 2-off M2.5 screws provided, as shown
in Figure 6.
Figure 6 - Rack mounting the Module
WARNING
Ensure that all electrical wiring is safely secured so that people cannot trip on them.
To Next Page
Loading...
Need help?
General
