© Edwards Limited 2010. All rights reserved. Page 31
Edwards and the Edwards logo are trademarks of Edwards Limited.
Operation
D397-50-880 Issue C
Input bytes (to Master)
No Alerts currently exist for these software modules so the 2nd and 3rd bytes will always be zero.
Associated Parameter options
None.
4.8.13 Software module 909 - Turbo Cycle Time
This module can be used with any Turbo pump that is compatible with a TIC unit.
General Description
Monitors turbo pump running time, since it was last started.
Output bytes (from Master)
None.
Input bytes (to Master)
No Alerts currently exist for these software modules so the 4th and 5th bytes will always be zero.
Associated Parameter options
None.
4.8.14 Software module 910 - Backing pump control
This module can be used with any TIC that includes pump control.
General Description
Controls Backing Pump.
Output bytes (from Master)
Input bytes (to Master)
No Alerts currently exist for these software modules so the 2nd and 3rd bytes will always be zero.
Associated Parameter options
None.
1st Whether Standby speed mode is set: 0 =No; 4 = Yes.
2nd Alert - refer to table in Appendix A2.
3rd Priority - refer to table in Appendix A3.
1st First two bytes form a 16-bit number which is the turbo
running time in hours since the pump was started.
2nd
3rd State - refer to table in Appendix A1.
4th Alert - refer to table in Appendix A2.
5th Priority - refer to table in Appendix A3.
1st Backing pump control (1 = run; 0= stop).
1st State - refer to table in Appendix A1.
2nd Alert - refer to table in Appendix A2.
3rd Priority - refer to table in Appendix A3.
To Next Page
Loading...
Need help?
General
