61Use instructions
3.1.1.10 Dual drive
Setting the exchange between the exciters in manual/automatic mode, as well as the
maximum number of times for the exchange. Indication of which exciter is
on the antenna and which is on the load. By selecting “CHANGE” here, it is possible to
force the exchange.
3.1.1.11 Dual drive drive
Setting the exchange between the exciters in manual/automatic mode, as well as the
maximum number of times for the exchange. Indication as to whether the exciters are
“On Air” or not, and in alarm or not.
3.1.1.12 Dual drive handler
Setting the exchange between the exciters in manual/automatic mode, viewing the
relay position, assigning the exciters to the antenna or the load.
3.1.1.13 Temperatures DL
Indication of the maximum temperature detected on the dummy load, the envirnment
temperature, the individual temperatures detected on each load module.
The temperature indications depend on the presence of probes inside the equipment.
Thus, on certain types of equipment some of these values may not be available.
To Next Page
Loading...
Need help?
General
