71Use instructions
Other parameters that can be set from this menu are the machine addresses (reference
for communication with it).
3.1.2.8 Password recovery
If you lose your password, please contact Elenos.
Elenos must be given the “Unlock code” in this screen.
Elenos will provide a password valid for 24 hours to be entered on the same screen
under the “Password Recovery” item.
The user must later define new passwords through the “Password Setting” screen.
3.1.2.9 System config
Setting and display screen.
The following parameters can be set by the user: temperature measurement unit
(Temp. U.), remote display operating mode (Show D.), equipment protection in case
of oscillations (PwOscChk), power target when working with a UPS (UPS T), minimum
number of sensors on which to perform the check on the functionality resulting in sen-
ding alarm (Min T.Sen), power reading calibration (FwdPwrCal), SWR foldback, polariza-
tion threshold (IPA Bias Tres.), reflected power nominal threshold (Refl.Pwr T.N., when
active it is 10% of direct power), reflected power customized threshold (Refl.Pwr T.Lev.,
when the nominal threshold is inactive, it is possible to set values below10%), final
polarization (PAbias), maximum settable power full scale (Max Target Pwr).
Power oscillation algorithm
In Elenos devices, if there is a power variation of “n” W (“n” being defined in specific
tables) at least 3 consecutive times within 15 seconds, the “035” alarm is activated and
the three block out mechanism is triggered (if this mechanism fails, the “003” alarm is
then activated).
To Next Page
Loading...
Need help?
General
