Navigation Keys Programming Setup and UI Navigation for RLDS - Display Screens • 27
7 Programming
Setup and UI
Navigation for
RLDS - Display
Screens
7.1. Navigation Keys
• Use the arrow/cursor keys for multi-directional
movement in making selections and moving the
cursor.
•Use the ENTER key to initiate and complete a
selection.
•Use the ESC key to go back during program-
ming or silence an alarm in alarm mode.
7.2. Initial Power Up
When the RLDS is first powered up, all front level
panel LEDs will illuminate, and a splash screen will
appear and display the monitor’s firmware version
level. After a moment the Warm Up screen will be
displayed and the green MONITOR ON light (green)
will blink.
After a 15-minute warm-up cycle, the MONITOR
ON light will glow steadily and the Status screen will
be displayed:
7.3. Navigate to the First
Setup Screen
1. Use the up/down cursor keys to select the first
text box to access the Setup screen.
2. Press ENTER to select.
Figure 7-1 - RLDS Front Panel Navigation Keys
Figure 7-2 - Status Screen
NOTE: “RLDS Setup Screens - System Map”
on page 43
Figure 7-3 - Setup Screen 1
To Next Page
Loading...
Need help?
General
