[] Supplied Accessories
owner's manual remote control
(NF604UD)
batteries Phillips pan screw for
(AA x 2) attaching the stand x 2
(FPH34140)
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
• Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters).
Contact your local electronics store for these items.
[] Attaching the Stand
You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.
Turn the main unit over and place
it onto a table which has a soft
cloth draped over it. Make sure
not to damage the screen.
Insert the stand all the way to the
main unit slowly.
Make sure not to put the AC cord
between the stand and the unit.
Drive Phillips pan screws in the 2
threaded holes with a screwdriver
tightly.
\\
Note:
• Whenattaching the stand, ensure that all screws are tightlyfastened. If the stand isnot properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and islarger than this unit.
• Make sure the table is in a stable location.
[] Symbols Used in this Manual
The following is the description for the symbols used
in this manual. Description refers to:
: Digital TV operation
: Analog TV operation
• If neither symbol appears under the function
heading, operation is applicable to both.
[] Trademark Information
• Manufactured under license from Dolby Laboratories.
"Dolby"and the double-D symbol are trademarks of
Dolby Laboratories.
• Product that have earned ENERGY STAR®are designed
to protect the environment through superior energy
efficiency.
[]Tilt Stand
You can adjust the stand to change the angle
of the TV (-3 ° to 8°).
ii li
8 °
/
7
i
EN
To Next Page
Loading...
Need help?
General
