ENSONIQ SQ-R User Manual

section 6 - Storage Functions
Formatting a Blank Memory Card
When you first install the battery in a RAM card, the card will not be recognized
by the SQ-R until it is formatted. Formatting a card is done by simply storing a
sound bank or preset data to the card. With a new card, you first decide whether
you want to use it to store sounds, presets or both (see the note on the previous
page) and then format it, either by copying the internal sounds to Card A, or by
saving the internal preset memory to the card.
SOUNDS
Copying Sounds Between Internal and Card Memory
The functions described here are used to do "bulk copies" of the 80 INT sounds
to the memory card, or vice-versa. Also, as noted above, it is necessary to copy
die internal sounds to Card A before the card can be used to store sounds at all. If
you wish to copy a single sound to a different location, use instead the procedure
described in Section 5.
To Copy sound banks between Internal and Card memory:
• Press the System button.
• Press the Right Arrow or System button repeatedly until the display reads:
Press ENTER to
Store Sounds
Press Enter/Save. The display now lets you choose which type of storage to
use.
Use the Up/Down Arrow buttons to select "Storage Type=MEMORY
CARD," as shown below:
Storage Type
MEMORV CflRD
Press Enter/Save. The display now offers four choices:
"Operation = COPY
contents of the eight
"Operation = COPY
contents of the eight
"Operation = COPY
contents of the eight
memory.
"Operation = COPY
contents of the eight
memory.
INT TO CARD A" — this command copies the entire
INT Sound Banks (0-7) to CARD A.
INT TO CARD B" — this command copies the entire
INT Sound Banks (0-7) to CARD B.
CARD A TO INT" — this command copies the entire
CARD A Sound Banks (0-7) to the Internal (INT)
CARD B TO INT" — this command copies the entire
CARD B Sound Banks (0-7) to the Internal (INT)
Memory Card Storage
8 - 3

ENSONIQ SQ-R Specifications

General

Brand	ENSONIQ
Model	SQ-R
Category	Synthesizer
Language	English