ENSONIQ SQ-R User Manual

Section 3 - Presets
SQ-R Musician's Manual
r
Remember:
next program change received on that track will select a new sound and also
install the effect from that sound into the preset effect. This is the only way to
change the preset effect other than manually editing the settings or selecting a new
preset. This can be useful when controlling the SQ-R from an external
sequencer.
This special program change 124 does not change the way in which other
program changes are received, including the other special messages. If the sound
you wish to select also requires a special control program change, then send the
control message immediately after the 124 followed by the program number you
want to select.
All SQ-R program changes are referred to and displayed as 001 to 128, but the
actual codes transmitted and received over MIDI are the number minus one (000
to 127)
Selecting a New Preset with Program Changes
When the SQ-R is in Preset Select mode (with the Select Preset LED lit) and the
Preset Prog switch is ON (in the System bank), program changes received on the
base channel (in OMNI, POLY and MULTI modes) or the global controller
channel (in MONO A and MONO B modes) will select a new preset.
MIDI Status
Parameter Bank
r
Track 1
Status = BOTH
OH
MIDI Status
This screen determines the MIDI Status of a track. The four possible settings are:
• BOTH Incoming notes, controllers, etc., will play locally and will be
retransmitted via MIDI over the selected MIDI channel when
Retransmit=ON. Incoming MIDI will play internal voices.
• LOCAL The track will only play internal voices, and will not send any data out
MIDI, even with Retransmit on. Incoming MIDI will play internal
voices.
• MIDI Notes, controllers, etc., will be sent out via MIDI when the track
receives incoming MIDI information and the Retransmit parameter is
set to ON. However, MIDI data coming in on the track will not play
any SQ-R voices at all. This is comparable to Local Off on some
systems. Use this status when you want to create MIDI-only tracks
for playing remote MIDI devices. When MIDI status has been
selected for a track, instead of showing the program name, the display
will show *MIDI-CHAN-#, indicating its status and what MIDI
channel it is sending on (assuming the MIDI-TRK-NAMES switch in
the MIDI bank is OFF; see Section 2 — System Control).
3 - 12
Performance Parameters

ENSONIQ SQ-R Specifications

General

Brand	ENSONIQ
Model	SQ-R
Category	Synthesizer
Language	English