ENSONIQ SQ-R User Manual

Section 3 - Presets SQ-R Musician's Manual
r
Output
Mix Bank
Output
Normally, different voices in a sound are assigned to the three different busses,
as set in the Output bank. On this screen you can override the normal effects
routing of the program for each track. This may be useful when two sounds are
split or layered in a performance preset, and the effect is not appropriate for both.
The available settings are:
• DRY forces all voices to the dry bus
• FX1 forces FX2 voices to FX1; FX1 and DRY are unaffected
• FX2 forces FX1 voices to FX2; FX2 and DRY are unaffected
• VOICE uses normal voice routing
• CONTROL uses normal voice routing and also routes controller information
to the effect This is the default setting in the track after copying
a sound to a track.
Timbre
Mix Bank
Timbre
The Timbre parameter provides an easy way to make useful changes to the
character of a sound without getting into more complex programming. This
performance parameter uses the Up/Down Arrow buttons to control various
aspects of the sound, depending on what the programmer has decided would be
useful.
As one of the voice modulation sources, TIMBRE can be assigned to anything
that can be modulated in a program or effect. The Timbre control can be
connected to parameters such as filter cutoff, waveform modulation, LFO depth,
and others. It is a good idea to experiment with the Timbre setting to hear what it
has been programmed to do in each program.
Range: 00 to 99
All tracks whose MIDI Status is set to MIDI or BOTH will transmit a MIDI
Continuous Controller message (controller #71) with the indicated value
whenever this parameter is edited.
3 - 16 Performance Parameters

ENSONIQ SQ-R Specifications

General

Brand	ENSONIQ
Model	SQ-R
Category	Synthesizer
Language	English