ENSONIQ SQ-R User Manual

Section 3 - Presets SQ-R Musician's Manual
Abandoning Your Edits
If you decide, while editing a preset, that you're not happy with what you've
done, and you want to start over with the original preset:
Press the Select Preset button so the Preset Select screen displays the original
preset name. Then you can start editing the preset again from scratch. You will
lose the one you were working on before.
Saving a New Preset Into Memory
After creating a new preset, or editing an existing preset to better suit your needs,
it must be saved into a memory location in order to be available for future access.
New or edited presets can be saved into any one of the 80 preset locations with
the following procedure.
1) Check the Preset Select screen to make sure that the Edited Preset is displayed.
If not, press the Select Preset button. This indicates that the preset you're
hearing is in the edit buffer.
2) Press the Enter/Save button. This tells the SQ-R that you've finished editing
and are ready to save the preset to a memory location. The display will read
"Save Preset <PRESET NAME>?" The name listed is the name of the preset
you began with when editing.
3) Select a name of up to 16 characters for your new preset using the arrow
buttons. The Left/Right Arrow buttons select the character to be edited,
while the and Up/Down Arrow buttons scroll through the letters, numbers,
and icons that can be used to name the preset.
4) Press the Enter/Save button.
5) Select a memory location for your preset using the Left/Right and
Up/Down Arrow buttons. These buttons will select the presets currently
residing in internal memory.
Look for a memory location that contains a preset that you no longer want or
use. Presets that are in memory can be "auditioned" at this point by pressing
the Select Preset button to toggle between the preset listed on the screen and
the preset in the edit buffer.
6) When a location has been found, press the Enter/Save button. The display
will show a momentary "SAVED" message before returning to the Preset Select
mode.
Hint: If you would like your edited preset to be saved in its present memory location,
simply "double-click" the Enter/Save button. As in the above procedure the
display will momentarily read "SAVED" and then return to the Preset Select
mode.
Copying an Existing Preset to Another Location
Sometimes you'll want to take an existing preset, one that you haven't been
editing, and simply copy it to another memory location. For example, you might
want to put several presets used within the same tune in order, for easy access
during performance.
3 - 4 Saving Presets

ENSONIQ SQ-R Specifications

General

Brand	ENSONIQ
Model	SQ-R
Category	Synthesizer
Language	English