SecureStack B2 Installation Guide xv
About This Guide
Thisguideprovidesanoverview,installationandtroubleshootinginstructions,and
specificationsfortheEnterasys
®
SecureStackB2G124‐48PandB2H124‐48Pstackable
GigabitEthernetswitches.
Forinformationab outtheCommandLineInterface(CLI)setofcommandsusedto
configureandmanagetheB2G124‐48PorB2H124‐48P,refertotheEnterasys Networks
®
SecureStackB2ConfigurationGuide.
ThisprefaceprovidesanoverviewofthisguideandtheSecureStackB2manualset,and
explainsthesymbolsusedthroughoutthisguide.
Who Should Use This Guide
Thisguideisintended foranetworkadministratorresponsibleforinstallingandsetting
upthestackableswitches.
Note: In this guide, the following terms are used:
• Switch refers to both B2G124-48PandB2H124-48P, unless otherwise noted.
• MGBIC (Mini-Gigabit Interface Card) refers to optional small form pluggable (SFP)
interface modules that plug into the fixed front panel MGBIC slots.
• PoE refers to Power over Ethernet (IEEE 802.3af).
Important Notice
Depending on the firmware version used in the switch, some features described in this document
may not be supported. Refer to the Release Notes shipped with the switch to determine which
features are supported.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
To Next Page
Loading...
Need help?
General