SecureStack C2 Installation Guide xv
About This Guide
Thisguideprovidesanoverview,installationandtroubleshootinginstructions,and
specificationsfortheEnterasys Networks
®
SecureStackC2G124‐24,C2G124‐48,and
C2H124‐48stackableEthernetswitches.
Forinformationab outtheCommandLineInterface(CLI)setofcommandsusedto
configureandmanagetheswitches,refertotheEnterasys NetworksSecureStackC2
ConfigurationGuide.
Who Should Use This Guide
Thisguideisintendedforanetworkadministratorresponsibleforinstallingandsetting
upthestackableswitches.
Thisguideisintendedforanetworkadministratorresponsibleforinstallingandsetting
upthestackableswitches.
Note: In this guide, the following terms are used:
• Switch refers to all three switches (C2G124-24, C2G124-48, and C2H124-48)unless
otherwise noted.
• MGBIC (Mini-Gigabit Interface Card) refers to optional small form pluggable (SFP)
interface modules that plug into the fixed front panel MGBIC slots.
Important Notice
Depending on the firmware version used in the C2G124-24, C2G124-48, and C2H124-48 switches,
some features described in this document may not be supported. Refer to the Release Notes
shipped with the switch to determine which features are supported.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
To Next Page
Loading...
Need help?
General