Epiroc HM Series User Manual

Safety and operating instructions
32 © Construction Tools GmbH | 3390 5149 01 | 2020-09-22
Original Instructions
6.4 Correct operation
6.4.1 Lift load
n
Place the magnet plate on the load to be lifted.
n
Briefly press the control button.
LED 2 lights up. The magnet plate is magnetized and
remains on until the control button is pressed again.
The load is applied.
Note: If you press the control button again shortly after
switching on the magnet plate (even when the magneti-
zation process is running), the magnetization is can-
celled and the automatic quick demagnetization starts
immediately. In this case, the system may require sev-
eral magnetization processes until the maximum tractive
force of the magnet plate is available again.
60
70
80
90
100
2
1
6.4.2 Drop load
n
Move the magnet plate with the suspended load into
position for dropping the load.
n
Briefly press the control button.
LED 2 goes out and LED 3 lights up for the duration
of the automatic quick demagnetization.
The magnet plate is demagnetized. The load de-
creases from the magnet plat.
Note: When pressing the control button again during the
quick demagnetization process (LED 3 lights up), the
quick demagnetization is interrupted and the demagneti-
zation of the magnet plate is continued at the "normal"
speed, i.e. it takes much longer.
60
70
80
90
100
3
2
1

Epiroc HM Series Specifications

General

Brand	Epiroc
Model	HM Series
Category	Construction Equipment
Language	English