Epiroc HM Series User Manual

Safety and operating instructions
© Construction Tools GmbH | 3390 5149 01 | 2020-09-22
Original Instructions
43
8.10 LED 4, 5, 6 light up and 100% flash: Pre-alarm over temperature of
the control electronics
Cause Remedy By
The temperature in the control
electronics, has exceeded the
pre-alarm limit value.
Turn off the carrier and secure it against being switched
on again (for example, by removing the ignition key and
keeping it safe).
Check that the cooling air openings are free and that the
cooling air can flow freely. Clean the cooling air openings
with a damp cloth if necessary.
If overtemperature occurs repeatedly contact the Epiroc
Customer Center / Dealer in your area.
Carrier driver and
Epiroc Customer
Center / Dealer in
your area
Let be checked if there is dirt on the cooling air openings
on the generator back. Dirt can impede the flow of cooling
air. Let the cooling air openings be cleaned.
Epiroc Customer
Center / Dealer in
your area
8.11 LED 4, 5, 6 and 100% flash: Over temperature control electronics
Cause Remedy By
The temperature in the control
electronics has exceeded the al-
lowed limit, and the system is
switched off immediately without
warning.
Turn off the carrier and secure it against being switched
on again (for example, by removing the ignition key and
keeping it safe).
Check that the cooling air openings are free and that the
cooling air can flow freely. Clean the cooling air openings
with a damp cloth if necessary.
If overtemperature occurs repeatedly contact the Epiroc
Customer Center / Dealer in your area.
Carrier driver and
Epiroc Customer
Center / Dealer in
your area
Let be checked if there is dirt on the cooling air openings
on the generator back. Dirt can impede the flow of cooling
air. Let the cooling air openings be cleaned.
Epiroc Customer
Center / Dealer in
your area

Epiroc HM Series Specifications

General

Brand	Epiroc
Model	HM Series
Category	Construction Equipment
Language	English