Basic Operations
26
Adjusting the Projector's Tilt
If the projection screen is tilted (the left and right sides of the projector are at different heights) when the
projector is setup on a table, adjust the front foot so that both sides are level with each other.
Correcting Keystone Distortion
You can correct keystone distortion using one of the following methods.
Correct automatically Auto V-Keystone Automatically correct vertical keystone distortion.
Correct manually H-Keystone Adjuster Correct horizontal keystone distortion with the H-Keystone
slider.
H/V-Keystone Manually correct distortion in the horizontal and vertical di-
rections independently.
The projected screen becomes smaller when correcting keystone distortion. Increase the projection distance
to fit the projected screen to the screen size.
Correct automatically (Auto V-Keystone)
If the the projector detects movement during installation, vertical keystone distortion is corrected
automatically. If the projector detects movement after it has been left in the same position for two seconds
or more, the adjustment screen is displayed allowing you to make corrections.
Auto V-Keystone can make effective corrections within a projection angle of 30° top to bottom.
c
•
Auto V-Keystone only functions when Front is selected as the Projection mode. s Settings -
Projection p.71
•
If you do not want to use the Auto V-Keystone function, set Auto V-Keystone to Off. s Settings -
Keystone - Auto V-Keystone p.71
Correct manually (H-Keystone adjuster)
Move the H-Keystone Slider to the right or left to perform horizontal keystone correction.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
