E Paper stacker
Attach to the front of the printer as shown when printing multiple sheets continuously from the auto sheet feeder.
Printed paper stacks up in this tray after it is ejected. Remove this when printing on roll paper or cut sheets (1
sheet).
U “Installing and removing the paper stacker” on page 31
F Edge guide
Align these with the left and right edges of the paper loaded in the auto sheet feeder. Prevents paper from being fed
at an angle.
G Auto Sheet Feeder
You can load multiple cut sheets of A4 to A3 paper. The loaded paper is fed automatically allowing you to print
continuously.
U “Loading paper into the auto sheet feeder” on page 31
H Cut sheet cover
Open when using the auto sheet feeder or when loading cut sheet paper.
U “Loading Cut Sheet(1 sheet)” on page 34
When loading roll paper, open this cover and then open the roll paper cover.
To prevent dust from accumulating inside the printer, close the auto sheet feeder when it is not in use or when you
are not loading cut sheet paper.
I Front cover
Open when a paper jam occurs.
SC-F500 Series User's Guide
Introduction
8
To Next Page
Loading...
Need help?
General