F
Rub your finger over the areas indicated in the
illustration to secure the head maintenance kits
in place.
c
Important:
Secure the adhesive parts of the head
maintenance kits so that there are no parts
that have not been stuck down. Do not press
the cleaning pad too hard at this point. This
could deform the platen.
G
Close the printer cover, and then press
Continue.
Print head maintenance starts.
c
Important:
Do not open the printer cover while cleaning.
Cleaning stops if the cover is opened.
H
When a message prompting you to remove the
head maintenance kit is displayed on the
control panel screen, open the printer cover.
I
Remove the two head maintenance kits.
c
Important:
❏ Remove them carefully so that no dirt
gets on the surrounding area.
❏ Check the platen and clean it if it is dusty
or dirty.
U “Cleaning the Platen” on page 57
Do not reuse a head maintenance kit.
U “Handling Used Consumables” on
page 64
J
Close the printer cover, and then press Done.
Head Cleaning starts. When the procedure is
complete, Head Cleaning is finished.
Replacing the Auto Cutter
Blade
Replace the auto cutter blade if the media is not cut
cleanly or if the edges of the cut sections are fluffy.
Supported auto cutter blade
U “Options and Consumable Products” on page 94
Caution:
Do not store the auto cutter blade within the reach
of children. The blade of the auto cutter blade
could cause an injury. Pay careful attention when
replacing the auto cutter blade.
Use a cross-head screwdriver to replace the auto cutter
blade. Make sure you have a cross-head screwdriver
with you before replacing the cutter.
Replacement Procedure
You can check the procedure on the control panel
while working.
A
Press on the screen, and then press
Replace Auto cutter blade.
SC-F6400 Series/SC-F6400H Series User's Guide
Maintenance
63
To Next Page
Loading...
Need help?
General